User Manual

26
The transmitter does
not send a signal.
• Check that the transmitter’s
battery polarity has not
been reversed.
• The battery has run out
of power and needs to be
replaced.
TROUBLESHOOTING
The receiver is
not accepting the
transmitter’s code(s).
• Reset the code between
the receiver and the
transmitter(s) (see page 4).
The flash does not
fire or misfires.
• Check the batteries of each
device for low power and
replace if needed.
• Check whether the
receiver’s power switch is in
the On position.
• Reset the code between
the receiver and the
transmitter(s) (see page 4).
• Check whether the flash is
in manual mode.