User Manual

Channel

Setting an Aviator

Transceiver’s Channel

To set the desired Channel,

do the following:

1. From the TTL Screen or the Slave Mode

screen, press Menu to enter Channel

Select.

2. Use the + and − buttons to select the

desired channel from 1-16 (channels

5-16 are only available when using two

Aviator Transceiver units).

3. Press Select to apply the setting.

Setting an Aviator Receiver’s Channel

While the Receiver is O, slide the Channel

switch to the desired Channel (1, 2, 3

or Auto). Then turn the Receiver on.

Note: “Auto” is equal to the

Transceiver's Channel “4”

Note: all devices must be set to the same channel for the system to function properly.

SETTING CHANNELS