Datasheet

Send ‘wifi se ngs request’ from display device
(Tablet or USB host) to WiFi Scope
<STX>
<Wifi -se ngs-request-cmd> <Data_length_low_byte> <Data-length-high-byte>
<0> <0>
<CHKSUM>
<ETX>
Start of transmission: STX = 0x02
Data length: 8
Wi�i settings request command: 0x0A
Checksum: CHKSUM = 8-bit two’s complement of sum of all previous bytes
End of transmission: ETX = 0x0A
Send ‘wifi se ngs’ from display device (Tablet or
USB host) to WiFi Scope
<STX>
<Wifi -se ngs-cmd> <Data-length-low-byte> <Data-length-high-byte>
<0> <0>
<Wifi -channel-low-byte> < Wifi -channel-high-byte>
<SSID-char1> <SSID-char2> <SSID-char3> … <SSID-char32>
<Password-char1> <Password-char2> <Password-char3> … <Password-char32>
<CHKSUM>
<ETX>
Start of transmission: STX = 0x02
Data length: 74
Wi�i settings command: 0x0B
Wi�i channel: 1…13
SSID: Up to 32 characters (not used characters = 0)
Remark: At least one character must be used. Only the following characters are allowed: 0...9, a...z, A...Z, _ and -
Password: Up to 32 characters (not used characters = 0)
Checksum: CHKSUM = 8-bit two’s complement of sum of all previous bytes
End of transmission: ETX = 0x0A
Velleman NV.
- 4 -
@velleman_RnD