Datasheet

Receive WiFi se ngs from WiFi Scope to display
device (Tablet or USB host)
<STX>
<Status-wifi -se ngs-cmd> <Data-length-low-byte> <Data-length-high-byte>
<0> <0>
<Wifi -channel-low-byte> <Wifi -channel-high-byte>
<SSID-char1> <SSID-char2> <SSID-char3> … <SSID-char32>
<Password-char1> <Password-char2> <Password-char3> … <Password-char32>
<Build-digit1> <Build-digit2> <Build-digit3> <Build-digit4>
<Wifi -Firmware-version-char1> <Wifi -Firmware-version-char2> … <Wifi -Firmware-version-char16>
<CHKSUM>
<ETX>
Start of transmission: TX = 0x02
Data length: 94
Status Wi�i settings command: 0x22
Wi�i channel: 1…13
SSID: Up to 32 characters (not used characters = 0)
Password: Up to 32 characters (not used characters = 0)
Build: 4 characters for scope fi rmware build
Version: Up to 16 characters for wifi module scope fi rmware version
Checksum: CHKSUM = 8-bit two’s complement of sum of all previous bytes
End of transmission: ETX = 0x0A
Velleman NV.
- 11 -
@velleman_RnD