Datasheet

__________________________________________________________________________________________________________________________________________________________
7
9. MOUNTING THE FRONT PANEL
A.Mount the suitable spacers:
Pass the bolts through the conical holes of the front panel and put the
spacers over it before tightening them with nuts.
30mm M3 COUNTERSUNK-HEAD BOLT
M3 NUT
15mm PLASTIC SPACER
15mm PLASTIC SPACER
1.5mm FRONT PANEL
M3 NUT
30mm M3 COUNTERSUNK-HEAD BOLT
FRONT PANEL
B.Mount the PCB onto the spacers:
Fix the PCB on the front panel by using two lock washers and nuts.
Check the LED’s position and correct if necessary by heating the sol-
der points.
1.5mm FRONT PANEL
LOCK WASHER
15mm PLASTIC SPACER
30mm M3 COUNTERSUNK-HEAD BOLT
M3 NUT
M3 NUT
PCB
M3 NUT
LOCK WASHER
PCB
C.Stick the display window:
Depending the loudspeaker impedance you have to mount the correct
front panel:
- for 8 Ohm speakers use the scale 0.15 to 200W or 5 to 1000W
- for 4 Ohm speakers use the scale 0.3 to 400W or 10 to 2000W
REMARK: IF YOU MOUNT THIS POWER METER INTO THE SPEAKER
CABINET, ENSURE THE METER STAYS COMPLETELY AIRTIGHT.