Manual
Table Of Contents
- AMA2/AMA3
- HANDLEIDING
- MODE D'EMPLOI
- MANUAL
- ANLEITUNG
- SMS BERICHTEN VERZENDEN EN ONTVANGEN
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- Fxxxxy=z
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA3: type van het alarmtoestel
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30 (De drukknopled brand continu bij het aanzetten van het contact)
- AMA3 REV 4.30
- OUTPUT OFF/ON
- 4. HOE WEET IK WANNEER IK GPS ONTVANGST (FIX) HEB?
- FR – MODE D’EMPLOI
- ENVOYER ET RECEVOIR DES MESSAGES SMS
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA3: type de système d’alarme.
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3: device type
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30 (service on = led on the push button blinks fast)
- or
- AMA2/3 REV 4.30 (service off = led on the push button burns continuously)
- AMA3 REV 4.30
- DE – ANLEITUNG
- 1. INSTALLATION
- Der AMA2/3 funktioniert mit einer SIM-Karte damit er eine SMS-Nachricht senden kann.
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA2/3 REV 4.30
- AMA3: Typ Alarmgerät
- OUTPUT ON
- AMA2/3 REV 4.30
- OUTPUT OFF
- AMA2/3 REV 4.30
- SERVICE ON (die LED blind ständig beim Starten des Fahrzeuges)
- SERVICE OFF (die LED brennt beim Starten des Fahrzeuges)
- AMA3 REV 4.30
- OUTPUT OFF/ON
- AMA2/3 REV 4.30
2.5. POSITIVE TRIGGERED AUX INPUT
For positive triggering, be sure to use programming values 1,3 or 5 for function 2 (NC contact).
pic. 4
3. HOW DOES THE AMA2/3 WORK?
3.1. SWITCHING ON
Turn the ignition key in “OFF” position.
The AMA2/3 will alert immediately if he can reach you. The red led on the push button will flash and
you will hear an audible signal every time you switch OFF the ignition key.
As soon as you turn off the ignition, the AMA2/3 will indicate the signal strength through the buzzer
and the LED on the push button. 0-1 x blink/buzz = bad signal, 2-5 x blink/buzz = good signal. If the
signal is bad, please park your vehicle elsewhere to avoid communication failure with your AMA2/3.
60 seconds after removing the ignition key, the AMA2/3 will automatic be armed. The LED on the
push button will blink every 3 seconds.
3.2. SWITCHING OFF
If your vehicle is moved (lifted or replaced) the buzzer will sound and the LED on the push button will
flash. The AMA2/3 will give you 15 seconds (pre-alarm) to switch your ignition key into the “ON”
position. Now the AMA2/3 is switched OFF.
If the pre-alarm state is not canceled, the AMA2/3 will send a message with the following information
to your cell phone:
AMA2/3 REV 4.30
MOVING ALARM
CONTACT: OFF
BAT=OK SIG=4
GPS=0/1 AMA3
TIME:201446 AMA3
DATE:010707 AMA3
50:55:34 N AMA3
005:26:31 E AMA3
SPEED:0.00 AMA3
OUTPUT OFF/ON
25