User manual

HAM263D

00 (10/10/2008) VELLEMAN

• show the faulty zone(s) during disarmed condition with user code

• arm system instantly without delay

• clear the alarm memory of the whole system or only specific sections

• initiate dynamic battery test at anytime during disarmed mode

• initiate a 5-second operation of both timing and latch output relays to test the connected

siren/strobe light

• system code for direct access to programming mode in case the master code is forgotten

• fully Compatible with HAM263D alarm systems

• up to 4 keypads can be connected to the alarm system (HAM263D)

• extra keypads have the exact same functionality as the master keypad

• simply connect extra keypads in parallel with the master keypad

• long connection distance possible, up to 500 metres

5.3 Installation

• This keypad should be installed and serviced by a qualified person only.

• Choose an easily accessible location where the keypad is protected from harsh environmental

conditions such as rain and bright sunlight, and away from heat producing devices.

• Have a qualified person installing the electrical leads (4) that are necessary for the connection of

the keypad to the master control unit.

• Remove the keypad from the mounting frame by removing the screw at the bottom and pulling

gently forward.

• Mount the mounting frame over the leads coming from the master control unit. Do not damage

the leads when doing this.

• Remove the back cover of the keypad by removing the screws at the four corners.

• Make sure there is no power on the leads. Connect the leads to the connector block in the keypad

as indicated on the PCB.

• It is also possible to install a tamper switch (not included).

• Re-mount the back cover with the 4 screws.

• Place the keypad back in the mounting frame. Make sure the cabling is not damaged in the

process. Remount the screw at the bottom.

• Apply power to the leads (via the master control unit).

• There are no user-serviceable parts. Contact your dealer for spare parts if necessary.

5.4 Keypad description

A. General status LEDs

B. Zone status LEDs

C. Control key buttons