User manual

6. CUSTOM SETTING
To manage remote recording for all connected devices, click “ ” (simplified version) or “ ” (full
function version) → “ ” to go to the “Record Setting” page. The settings here will apply to all
connected devices, and all recordings will save in the location specified in “Record Path”.
Note: It’s recommended to specify the record path to the hard disk other than the boot
hard disk to protect your recording data.
6.1 Overview
Click “ ” (simplified version) or “ ” (full function version) → “ ” to go to the “Custom Setting”
page. There are three tabs to allow you make different preferences.
6.1.1 General
In this tab, users could:
 Choose the UI language from English, Chinese, French, German, Portuguese, Spanish and Japanese.
 Choose if Video Viewer should start automatically after Windows starts.
 Ask Video Viewer to remember the last status before it’s closed, and restore to the last status when it’s
activated again.
 Ask Video Viewer to prompt password check when it’s activated.
6.1.2 Connection
In this tab, users could configure the selected device in the address book to use Proxy server for
connection if needed to enhance its access speed, and enter its address and port used.
Note: This function is available only when the selected device is disconnected.
20