Data Sheet

INSTRUCCIONES DE TRABAJO
Versión nº: 2 Fecha de revisión: Septiembre 2011
IDT-605: Fichas técnicas de producto
Velcro Europe, S.A.: Toda la documentación gestionada mediante el software “GESDOC” está sometida a un sistema de control de la documentación. Cualquier copia impresa debe ser considerada instantáneamente
obsoleta a excepción de la “copia controlada”. El contenido de este documento debe considerarse confidencial y de uso interno
PRESSURE SENSITIVE PS-18
Base material : Water based acrylic polymer
Colour : Colourless
Shelf Life : Maximum 5 Years, when stored in dark area, at temperature of 10°C to 30°C.
Suggested uses : On most clean and smooth surfaces. (Except polypropylene and other non-polar material )
Adhesives Properties
Peel Strength 180°:
Curing time 20 minutes Minimum 8 N/cm Test method : FINAT ; FTM 1
Average 20 N/cm
Curing time 24 hours Minimum 10 N/cm Test method : FINAT ; FTM 1
Average 22 N/cm
Static Shear Strength:
3 days
Test method : FINAT ; FTM 8
Softening Point:
120°C
Test method : ASTM D-816
FINAT: Fédération Internationale des fabricants transformateurs d'Adhésifs et Thermocollants. ASTM: American Society for Testing and Materials.
Tested on: Anodized aluminium plates under laboratory conditions. (23°C ± 2 and 60 ± 10 % R.H.)
Resistance properties
Oxidation Excellent
Plastifying, oils Excellent
High relative humidity Poor
Polar solvents (M.E.K. etc.) Poor
Non-polar solvents (gasoline, etc.) Good
Migration Good
High temperature Good
Low temperature Good
U.V. radiation Excellent
Temperature Range -20°C to +120°C (Depending on loading and Relative Humidity).
General Directions for Use
Minimum recommended bonding temperature: 10°C.
Degrease the substrate with e.g. alcohol or spirit. (The substrate must be free of grease, moisture, dust, silicones, etc.).
Remove the protective paper and press the tape firmly into contact with the substrate, with special attention to the edges.
Preferably, allow substrate and pressure sensitive tape to stand for 24 hours after applying load.
* Internal norm of VESA
The information included in this Technical Sheet is based on reliable test and trials.çaverage value as a reference only, not a nominal specification. Given the
diversity of uses of our products we advice our customers to assure themselves that the product meets the requirements of their application. The responsibility for
the application and use of the product remains with the customer.
Elaborado:
J.C. Lima
Revisado:
E. Ducet
Autorizado:
J. Jacobs
Fecha: 11.10.11
ANEXO: IDT – 605-B
FTP 502 Versión 5