Instructions / Assembly

Pg.6
Attach triangle cap (G) to assembled middle cross beam (C)
Assemble six side glidewheels (M) into side cross
beam (E), and then connect side cross beam 1 (E)
& side cross beam 2 (E1) with inside connector (N1)
by bolt (P3) & nut (Q) & nut cap(O) & bolt cap (R) to
make sue there is no gap between the two tubes by
tighting the bolt
Attach triangle cap (G) to side cross beam 1 & 2 (E & E1)
Connect bottom cross beam 1 (D) and bottom cross
beam 2 (D1) & beam3(D2) with inside connector (N)
by bolt (P4) & nut (Q) & nut cap(O) & bolt cap(R) to
make sue there is no gap between the two tubes by
tighting the bolt. Make sure the bottom cross beam
1 & 2 (D & D1 & D2) is in the same direction
Attach triangle cap (G) to assembled bottom cross beam (D & D1)
Connect two enhanced support beams (F) with
inside connector (N2) by bolt (P4) & nut (Q) & nut
cap (O) & bolt cap (R) to make sue there is no gap
between the two tubes by tighting the bolt