Installation Guide

Pg.6

Attach triangle cap (G) to assembled middle cross beam (C)

Assemble six side glidewheels (M) into side cross

beam (E), and then connect side cross beam 1 (E)

& side cross beam 2 (E1) with inside connector (N1)

by bolt (P1) & bolt cap (R)

the two tubes by

to make sue there is no gap between

tighting the bolt

Attach triangle cap (G) to side cross beam 1 & 2 (E & E1)

Connect bottom cross beam 1 (D) and bottom cross

beam 2 (D1) & beam3(D3) with inside connector (N2)

by bolt (P1) & bolt cap(R) to

is no gap between the two tubes by

make sue there

tighting the bolt. Make sure the bottom cross beam

1 & 2 (D & D1 & D3) is in the same direction

Attach triangle cap (G) to assembled bottom cross beam (D & D1)

Connect bottom cross beam 1 (D) and bottom cross

beam 2 (D1) & beam3(D2) with inside connector (N2)

by bolt (P1) & bolt cap (R)to

between

make sue there is no gap

the two tubes by tighting the bolt. Make sure the

Make sure the bottom cross beam

1 & 2 (D & D1 & D2) is in the same direction