Installation Guide

Pg.5

Attach post top cap (A) to post (1 & 2)

Attach and fasten stake piece (U) to the

end of post (3) by bolt (P1) and cap (R)

Insert post connector (J) into post (3) by

bolt (P1) and bolt cap (R)

Attach decorative circle (K) to post (3),

and attach post (1 & 2) to post (3) by

bolt (P1) and bolt cap (R)

Connect two middle cross beams (C) with

inside connector (N1) by bolt (P1)

& bolt cap (R)

to make

sure that there is no gap between the two

middle cross beams (C) by tighting the bolts

"Assemble 5pcs of middle glidewheels (Y) and drawstring glidewheels with magnet (B)

into middle cross beam (C). Seperate the middle glidewheels (Y) by using bolt (P4) & nut

(Q) & bolt cap (R) & nut cap (O)

Attention: please joint two tubes together without gap and then assemble the screws"

PCS)