Installation Guide Owner's manual

Connecting to Ethernet

TH LINK | Trebing & Himstedt Prozeßautomation GmbH & Co. KG

Uninstalling the TH LINK

1. Remove the connected supply and signal lines (Ethernet,

PROFIBUS, voltage).

2. Place the screwdriver into the stop lever on the TH LINK

(

see figure 2).

3. Press the screwdriver in the direction of the TH LINK and

simultaneously swing the device off the top-hat rail.

Connecting to Ethernet

– Insert the patch cable plug (RJ-45, not included in the scope of

delivery) into the Ethernet socket (

see figure 1 no. [1]) on the

TH LINK until the plug locks into place.

– The green LED on the Ethernet socket lights as soon as the

LINK is energized and an Ethernet network is available.