Supplementary instructions DIS-ADAPT Adapter for connection of an external display and adjustment unit Document ID: 45250
Contents Contents 1 For your safety 1.1 Appropriate use................................................................................................................. 3 1.2 General safety instructions................................................................................................ 3 1.3 Safety instructions for Ex areas......................................................................................... 3 2 Product description 3 Mounting 3.1 Mounting preparations...................
1 For your safety 1 For your safety 1.1 Appropriate use 1.2 General safety instructions 1.3 Safety instructions for Ex areas DIS-ADAPT is a retrofit component for existing plics® sensors for connection of an external display and adjustment unit. The safety information in the operating instructions manual of the respective sensor must be noted. 45250-EN-130625 Please note the Ex-specific safety information for installation and operation in Ex areas.
2 Product description 2 Product description Scope of delivery The scope of delivery encompasses: Application area The adapter DIS-ADAPT is an accessory part for the following plics® sensors with double chamber housing. • • • • • Adapter with connection cable and M12 x 1 plug Documentation –– this operating instructions manual VEGAPULS series 60, hardware from 2.0.0, software from 4.0.
3 Mounting 3 Tools Mounting 3.1 Mounting preparations The following tools are required for mounting: • • Spanner SW 17 or hexagon socket size 8 for unscrewing the blind plug Spanner SW 17 for screwing in the M12 x 1 plug 3.2 Mounting steps Proceed as follows to mount the DIS-ADAPT: 1. Open the cover of the electronics compartment 1 2 Fig. 2: Position of the electronics compartment and the blind plug 1 2 Electronics compartment Blind plug 2.
3 Mounting 1 2 Fig. 3: Attach the adapter 1 2 Place Turn The mounting of DIS-ADAPT is finished. Removal is carried out in reverse order.
4 Connecting Electronics compartment 4 Connecting 1 2 3 Fig. 4: View to the electronics compartment with mounted DIS-ADAPT 1 2 3 DISADAPT Internal cable connection Plug connector M12 x 1 Wiring plan 4 3 1 2 Fig.
4 Connecting Connection example 6 3 4 1 5 Display 2 Fig.
5 Supplement 5 Supplement 5.1 Technical data Materials Contact plate Plastic (PBT) M12 x 1 plug 316L ƲƲ Seal FKM Adjustment circuit Connection to VEGADIS 81 Data transmission digital (I²C-Bus) Configuration, connection cable 4-wire, screened Cable length depending on the sensor version Protection rating Sensor with connected cable ƲƲ Pressure transmitter IP 66/IP 67 ƲƲ Other sensors 5.2 IP 66/IP 68 (0.2 bar) Dimensions DIS-ADAPT 8,9 mm (0.35") 87,5 mm (3.45") 43,5 mm (1.
Notes 45250-EN-130625 10 DIS-ADAPT • Adapter for connection of an external display and adjustment unit
45250-EN-130625 Notes DIS-ADAPT • Adapter for connection of an external display and adjustment unit 11
All statements concerning scope of delivery, application, practical use and operating conditions of the sensors and processing systems correspond to the information available at the time of printing. Subject to change without prior notice © VEGA Grieshaber KG, Schiltach/Germany 2013 VEGA Grieshaber KG Am Hohenstein 113 77761 Schiltach Germany Phone +49 7836 50-0 Fax +49 7836 50-201 E-mail: info.de@vega.com www.vega.
