Manual

1 For your safety
1.1 Appr
opriate use
The connection cable is used to retrofit existing plics sensors to
achieve protection IP 66/IP 68 (1bar).
1.2 Impermissible use
As a rule, the connection cable is not allowed to be used with four-wire
instruments. Four-wire instruments are sensors whose power supply
and measurement signal are transmitted over two separate pairs of
wires.
1.3 General safety instructions
The safety information in the operating instructions manual of the
respective sensor must be noted.
1.4 Safety instructions for Ex areas
Please note the Ex-specific safety information for installation and
operation in Ex areas. These safety instructions are part of the
operating instructions manual and come with the Ex-approved
instruments.
For instruments with Exd or StEx approval, the use of this connection
cable is not allowed.
Connection cable IP 66/IP 68 (1 bar) • Retrofit
set/Accessory for plics sensors 3
1 For your safety
34107-EN-120524