Manual

5 Turn the potentiometer (6) clockwise according to the
following chart.
6 The probe is now ready for operation.
Sensitivity
Standard very sensitive
VEGACAP 27, 98
DK value >2
= 2 turns
DK value >1.5
= 1 turn
VEGACAP 35
DK value >1.5
= 2.5 turns
-
Tab. 1: Number of additional turns for the potentiometer (6)
Note:
With the measurement of products with very low dielectric
values, the number of turns can be reduced up to 1 according
to the chart.
This setting is too sensitive with conductive, adhesive
products.
Note:
When placing the housing cover, make sure that the inspection
glass is above the signal lamp of the oscillator.
10 Electronics module - CAP E31R
Setup
33761-EN-070809