Operation Manual
Table Of Contents
- 1. Terms, signs and symbols
- 2. General notes on safety
- 3. About this manual
- 4. Specification
- 5. Device description
- 6. Starting
- 6.1. MobileTouchet up of 53 charging station
- 6.2. Inserting and charging B50 batteries
- 6.3. Installing a wireless network
- 6.4. Installing Bluetooth
- 6.5. Attaching the wrist strap at the MobileTouch POS system
- 6.6. Attaching the safety strap at the MobileTouch POS system
- 6.7. Attaching the leather holster
- 6.8. Fastening the belt
- 6.9. Attaching the safety strap at the leather holster
- 7. Operation
- 7.1. MobileToucholding the 75 POS system
- 7.2. Transporting the MobileTouch POS system
- 7.3. Switching on the MobileTouch POS system and switching it to quiescent condition
- 7.4. Charging the battery B50
- 7.5. Exchanging the battery
- 7.6. Entering data to the MobileTouch POS system
- 7.7. Sign in and out at the MobileTouch POS system
- 7.8. Working with guest checks
- 7.8.1. Opening a GC
- 7.8.2. Booking PLUs to a guest check
- 7.8.3. Closing a GC
- 7.8.4. Finalizing a GC
- 7.8.5. Splitting PLUs of a guest check to invoice
- 7.8.6. Splitting single PLUs of a guest check to another guest check
- 7.8.7. Moving all PLUs of one guest check to another guest check
- 7.8.8. Transferring a guest check to another operator
- 7.9. Working with reports
- 7.10. Void and Correction
- 7.11. Using a wireless network for data transfer
- 7.12. Restarting the MobileTouch POS system
- 8. Shut down
- 9. Errors, possible reasons and troubleshooting
- 10. Service and maintenance
- 11. Disposal
- 12. Glossary
- 13. Icons
- 14. EC Declaration of conformity
- 15. Accessories
- 16. Other Vectron products
99
EN
7.10. Void and Correction
This chapter informs you about the void function. Whether
or not you can use this function depends on programming
and configuration of your MobileTouch POS system.
You can cancel bookings if for instance an operator made
false entries. Furthermore, you can program and configure
the MobileTouch so that PLUs are cancelled and the re-
spective invoice is corrected, if a customer returns items.
7.11. Using a wireless network for data transfer
This chapter tells you how to use the wireless network for
data transfer.
Prerequisite for using a wireless network is that it was
installed as described in chapter 6.3 “Installing a wireless
network” on page 64.
Functions like e.g. calling a GC only work if radio commu-
nication between MobileTouch POS system and an access
point is established. This depends on the programming of
your MobileTouch POS system, e.g. when guest checks are
stored on a GC server.
If radio communication between MobileTouch POS sys-
tem and an access point is interrupted, it is automatically
restored as soon as the radio signal is available again.
Data stored on the MobileTouch POS system is transferred
afterwards.