Operation Manual
Table Of Contents
- 1. Terms, signs and symbols
- 2. General notes on safety
- 3. About this manual
- 4. Specification
- 5. Device description
- 6. Starting
- 6.1. MobileTouchet up of 53 charging station
- 6.2. Inserting and charging B50 batteries
- 6.3. Installing a wireless network
- 6.4. Installing Bluetooth
- 6.5. Attaching the wrist strap at the MobileTouch POS system
- 6.6. Attaching the safety strap at the MobileTouch POS system
- 6.7. Attaching the leather holster
- 6.8. Fastening the belt
- 6.9. Attaching the safety strap at the leather holster
- 7. Operation
- 7.1. MobileToucholding the 75 POS system
- 7.2. Transporting the MobileTouch POS system
- 7.3. Switching on the MobileTouch POS system and switching it to quiescent condition
- 7.4. Charging the battery B50
- 7.5. Exchanging the battery
- 7.6. Entering data to the MobileTouch POS system
- 7.7. Sign in and out at the MobileTouch POS system
- 7.8. Working with guest checks
- 7.8.1. Opening a GC
- 7.8.2. Booking PLUs to a guest check
- 7.8.3. Closing a GC
- 7.8.4. Finalizing a GC
- 7.8.5. Splitting PLUs of a guest check to invoice
- 7.8.6. Splitting single PLUs of a guest check to another guest check
- 7.8.7. Moving all PLUs of one guest check to another guest check
- 7.8.8. Transferring a guest check to another operator
- 7.9. Working with reports
- 7.10. Void and Correction
- 7.11. Using a wireless network for data transfer
- 7.12. Restarting the MobileTouch POS system
- 8. Shut down
- 9. Errors, possible reasons and troubleshooting
- 10. Service and maintenance
- 11. Disposal
- 12. Glossary
- 13. Icons
- 14. EC Declaration of conformity
- 15. Accessories
- 16. Other Vectron products
98
VECTRON POS MOBILETOUCH
7.9. Working with reports
This chapter informs you about the report function. Wheth-
er or not you can use this function depends on program-
ming and configuration of your MobileTouch POS system.
In reports you can evaluate data that was stored in the
POS system. The Vectron POS software provides several
standard reports. You can display and print PLU- and op-
erator reports for example. A PLU report can contain e.g.
PLU numbers, PLU names, the number of sold PLUs, the
sales per PLU and the total sales. An operator report can
contain e.g. the proceeds of the operators and the sales
per customer.
You can create two types of reports with Vectron POS
software: X-reports and Z-reports. X-reports are intermedi-
ate reports, where the data is not deleted from the book-
ing memory. You can display, print and store X-reports as
often as you want to. Z-reports are final reports, where
the data is deleted from the booking memory. Output of
Z-reports is only possible once, since the data is deleted
from the booking memory after output.
Your Vectron dealer can program and configure reports
according to your requests.