Operation Manual
Table Of Contents
- 1. Terms, signs and symbols
- 2. General notes on safety
- 3. About this manual
- 4. Specification
- 5. Device description
- 6. Starting
- 6.1. MobileTouchet up of 53 charging station
- 6.2. Inserting and charging B50 batteries
- 6.3. Installing a wireless network
- 6.4. Installing Bluetooth
- 6.5. Attaching the wrist strap at the MobileTouch POS system
- 6.6. Attaching the safety strap at the MobileTouch POS system
- 6.7. Attaching the leather holster
- 6.8. Fastening the belt
- 6.9. Attaching the safety strap at the leather holster
- 7. Operation
- 7.1. MobileToucholding the 75 POS system
- 7.2. Transporting the MobileTouch POS system
- 7.3. Switching on the MobileTouch POS system and switching it to quiescent condition
- 7.4. Charging the battery B50
- 7.5. Exchanging the battery
- 7.6. Entering data to the MobileTouch POS system
- 7.7. Sign in and out at the MobileTouch POS system
- 7.8. Working with guest checks
- 7.8.1. Opening a GC
- 7.8.2. Booking PLUs to a guest check
- 7.8.3. Closing a GC
- 7.8.4. Finalizing a GC
- 7.8.5. Splitting PLUs of a guest check to invoice
- 7.8.6. Splitting single PLUs of a guest check to another guest check
- 7.8.7. Moving all PLUs of one guest check to another guest check
- 7.8.8. Transferring a guest check to another operator
- 7.9. Working with reports
- 7.10. Void and Correction
- 7.11. Using a wireless network for data transfer
- 7.12. Restarting the MobileTouch POS system
- 8. Shut down
- 9. Errors, possible reasons and troubleshooting
- 10. Service and maintenance
- 11. Disposal
- 12. Glossary
- 13. Icons
- 14. EC Declaration of conformity
- 15. Accessories
- 16. Other Vectron products
90
VECTRON POS MOBILETOUCH
7.7. Sign in and out at the MobileTouch POS
system
This chapter tells you how to sign in and out at the
MobileTouch POS system.
i
Buttons that are mentioned in this chap-
ter and that can be displayed as graphi-
cal elements, are shown in chapter 13
“Icons” on page 122.
7.7.1. Sign in at the MobileTouch POS system
Depending on the programming and configuration of your
MobileTouch you have to sign in at the POS system. Only
then you can enter PLUs for example.
The Vectron POS software stores the entries and assigns
them to the respective operator. You can assign access
rights for every operator, which determine the functions
for which he is authorized.
• Press the button <Function.>.
• Press the button <Mod. functions 2>.
• Enter the operator number to the numeric pad.
• Press the <Operator> button to sign in this operator.
i
The profile of the selected operator may
be protected with a secret code. You
have to enter the secret code for sign-in.