Operation Manual
Table Of Contents
- 1. Terms, signs and symbols
- 2. General notes on safety
- 3. About this manual
- 4. Specification
- 5. Device description
- 6. Starting
- 6.1. MobileTouchet up of 53 charging station
- 6.2. Inserting and charging B50 batteries
- 6.3. Installing a wireless network
- 6.4. Installing Bluetooth
- 6.5. Attaching the wrist strap at the MobileTouch POS system
- 6.6. Attaching the safety strap at the MobileTouch POS system
- 6.7. Attaching the leather holster
- 6.8. Fastening the belt
- 6.9. Attaching the safety strap at the leather holster
- 7. Operation
- 7.1. MobileToucholding the 75 POS system
- 7.2. Transporting the MobileTouch POS system
- 7.3. Switching on the MobileTouch POS system and switching it to quiescent condition
- 7.4. Charging the battery B50
- 7.5. Exchanging the battery
- 7.6. Entering data to the MobileTouch POS system
- 7.7. Sign in and out at the MobileTouch POS system
- 7.8. Working with guest checks
- 7.8.1. Opening a GC
- 7.8.2. Booking PLUs to a guest check
- 7.8.3. Closing a GC
- 7.8.4. Finalizing a GC
- 7.8.5. Splitting PLUs of a guest check to invoice
- 7.8.6. Splitting single PLUs of a guest check to another guest check
- 7.8.7. Moving all PLUs of one guest check to another guest check
- 7.8.8. Transferring a guest check to another operator
- 7.9. Working with reports
- 7.10. Void and Correction
- 7.11. Using a wireless network for data transfer
- 7.12. Restarting the MobileTouch POS system
- 8. Shut down
- 9. Errors, possible reasons and troubleshooting
- 10. Service and maintenance
- 11. Disposal
- 12. Glossary
- 13. Icons
- 14. EC Declaration of conformity
- 15. Accessories
- 16. Other Vectron products
64
VECTRON POS MOBILETOUCH
i
Complete charging of an empty battery
B50 takes approximately 2.5 hours.
Do not remove the battery B50 from
the MobileTouch until it is completely
charged.
6.3. Installing a wireless network
Via a wireless network the MobileTouch POS system can
send data to or receive data from other POS systems.
The MobileTouch POS system has a WiFi module, for inte-
grating the POS system to a wireless network in infrastruc-
ture mode. In infrastructure mode, an access point has to
be available and configured in order to use a wireless net-
work. The access point rules the communication between
the devices in wireless networks.
You can program and configure the WiFi module in that
way that Wireless LAN is exclusively activated when data is
sent, e.g. in order to save energy.
Your Vectron dealer can install the wireless network for
you. Please read the following hints and contact your
Vectron dealer for questions and requests concerning pro-
gramming and configuration.
NOTICE
a
External access to your data
X
Do not use unencrypted network
connections
X
Data transferred in the network
has to be encrypted
X
Have the encryption installed by
your Vectron dealer in any case to
protect your data from external
access