Operation Manual
Table Of Contents
- 1. Terms, signs and symbols
- 2. General notes on safety
- 3. About this manual
- 4. Specification
- 5. Device description
- 6. Starting
- 6.1. MobileTouchet up of 53 charging station
- 6.2. Inserting and charging B50 batteries
- 6.3. Installing a wireless network
- 6.4. Installing Bluetooth
- 6.5. Attaching the wrist strap at the MobileTouch POS system
- 6.6. Attaching the safety strap at the MobileTouch POS system
- 6.7. Attaching the leather holster
- 6.8. Fastening the belt
- 6.9. Attaching the safety strap at the leather holster
- 7. Operation
- 7.1. MobileToucholding the 75 POS system
- 7.2. Transporting the MobileTouch POS system
- 7.3. Switching on the MobileTouch POS system and switching it to quiescent condition
- 7.4. Charging the battery B50
- 7.5. Exchanging the battery
- 7.6. Entering data to the MobileTouch POS system
- 7.7. Sign in and out at the MobileTouch POS system
- 7.8. Working with guest checks
- 7.8.1. Opening a GC
- 7.8.2. Booking PLUs to a guest check
- 7.8.3. Closing a GC
- 7.8.4. Finalizing a GC
- 7.8.5. Splitting PLUs of a guest check to invoice
- 7.8.6. Splitting single PLUs of a guest check to another guest check
- 7.8.7. Moving all PLUs of one guest check to another guest check
- 7.8.8. Transferring a guest check to another operator
- 7.9. Working with reports
- 7.10. Void and Correction
- 7.11. Using a wireless network for data transfer
- 7.12. Restarting the MobileTouch POS system
- 8. Shut down
- 9. Errors, possible reasons and troubleshooting
- 10. Service and maintenance
- 11. Disposal
- 12. Glossary
- 13. Icons
- 14. EC Declaration of conformity
- 15. Accessories
- 16. Other Vectron products
53
EN
6.1. Set up of MobileTouch charging station
This chapter tells you how to set up the MobileTouch charg-
ing station and how to connect it to the voltage supply.
6.1.1. Selecting the setup site for the
MobileTouch charging station
This chapter informs you about the setup site for the
MobileTouch charging station.
NOTICE
a
Damage of MobileTouch charging
station through dropping and
unfavourable ambient conditions
X
Set up the MobileTouch charging
station as described in this
chapter
• Set up the MobileTouch in a well-ventilated room with
a temperature between 0 and 35 °C and air humidity
between 45 and 80 percent.
• Do not cover the charging station.
• Select the setup site so that the MobileTouch charging
station is not exposed to direct sunlight.
• Place the MobileTouch charging station on a stable, even
surface with sufficient space.
• Set up the MobileTouch charging station so that no
liquids can be poured over the charging station, power
supply and cable.
• Lay out the cables so that they are not under tension.
• Lay out the cables so that you do not trip over them.