Operation Manual
Table Of Contents
- 1. Terms, signs and symbols
- 2. General notes on safety
- 3. About this manual
- 4. Specification
- 5. Device description
- 6. Starting
- 6.1. MobileTouchet up of 53 charging station
- 6.2. Inserting and charging B50 batteries
- 6.3. Installing a wireless network
- 6.4. Installing Bluetooth
- 6.5. Attaching the wrist strap at the MobileTouch POS system
- 6.6. Attaching the safety strap at the MobileTouch POS system
- 6.7. Attaching the leather holster
- 6.8. Fastening the belt
- 6.9. Attaching the safety strap at the leather holster
- 7. Operation
- 7.1. MobileToucholding the 75 POS system
- 7.2. Transporting the MobileTouch POS system
- 7.3. Switching on the MobileTouch POS system and switching it to quiescent condition
- 7.4. Charging the battery B50
- 7.5. Exchanging the battery
- 7.6. Entering data to the MobileTouch POS system
- 7.7. Sign in and out at the MobileTouch POS system
- 7.8. Working with guest checks
- 7.8.1. Opening a GC
- 7.8.2. Booking PLUs to a guest check
- 7.8.3. Closing a GC
- 7.8.4. Finalizing a GC
- 7.8.5. Splitting PLUs of a guest check to invoice
- 7.8.6. Splitting single PLUs of a guest check to another guest check
- 7.8.7. Moving all PLUs of one guest check to another guest check
- 7.8.8. Transferring a guest check to another operator
- 7.9. Working with reports
- 7.10. Void and Correction
- 7.11. Using a wireless network for data transfer
- 7.12. Restarting the MobileTouch POS system
- 8. Shut down
- 9. Errors, possible reasons and troubleshooting
- 10. Service and maintenance
- 11. Disposal
- 12. Glossary
- 13. Icons
- 14. EC Declaration of conformity
- 15. Accessories
- 16. Other Vectron products
23
EN
Your Vectron dealer can configure the MobileTouch POS
system so that the integrated vibration informs you about
incoming messages, which for instance were sent from the
ServiceCall.
Shipment of the MobileTouch comprises one battery B50.
The lithium-ion battery supplies, depending on ambient
conditions and use, power for up to ten hours. The oper-
ating time depends for instance on whether the WLAN is
switched on and the power save function is programmed.
In addition to the battery, the MobileTouch POS system has
a buffer battery installed, which supplies the system while
you exchange the battery.
Your data remains stored in the MobileTouch POS system
in case of battery exchange or when the battery is empty,
because storage is made in a flash memory.
MobileTouch possesses a power save function, which can
be used to switch off components. Thanks to the lower
power consumption you can prolong the service life of the
MobileTouch POS system depending on ambient conditions
and use.
Your Vectron dealer should have adjusted the program-
ming and configuration of your MobileTouch POS system
according to your requirements.