Operation Manual
Table Of Contents
- 1. Terms, signs and symbols
- 2. General notes on safety
- 3. About this manual
- 4. Specification
- 5. Device description
- 6. Starting
- 6.1. MobileTouchet up of 53 charging station
- 6.2. Inserting and charging B50 batteries
- 6.3. Installing a wireless network
- 6.4. Installing Bluetooth
- 6.5. Attaching the wrist strap at the MobileTouch POS system
- 6.6. Attaching the safety strap at the MobileTouch POS system
- 6.7. Attaching the leather holster
- 6.8. Fastening the belt
- 6.9. Attaching the safety strap at the leather holster
- 7. Operation
- 7.1. MobileToucholding the 75 POS system
- 7.2. Transporting the MobileTouch POS system
- 7.3. Switching on the MobileTouch POS system and switching it to quiescent condition
- 7.4. Charging the battery B50
- 7.5. Exchanging the battery
- 7.6. Entering data to the MobileTouch POS system
- 7.7. Sign in and out at the MobileTouch POS system
- 7.8. Working with guest checks
- 7.8.1. Opening a GC
- 7.8.2. Booking PLUs to a guest check
- 7.8.3. Closing a GC
- 7.8.4. Finalizing a GC
- 7.8.5. Splitting PLUs of a guest check to invoice
- 7.8.6. Splitting single PLUs of a guest check to another guest check
- 7.8.7. Moving all PLUs of one guest check to another guest check
- 7.8.8. Transferring a guest check to another operator
- 7.9. Working with reports
- 7.10. Void and Correction
- 7.11. Using a wireless network for data transfer
- 7.12. Restarting the MobileTouch POS system
- 8. Shut down
- 9. Errors, possible reasons and troubleshooting
- 10. Service and maintenance
- 11. Disposal
- 12. Glossary
- 13. Icons
- 14. EC Declaration of conformity
- 15. Accessories
- 16. Other Vectron products
150
VECTRON POS MOBILETOUCH
16.3. Software
Vectron software serves for example for evaluating or
adjusting data of your POS systems.
16.3.1. Vectron Commander
Vectron Commander is a communication- and evaluation
software for Vectron POS systems. The software can be
used with computers with Microsoft
®
Windows
®
operating
system.
Via connection to the Vectron POS system the Vectron
Commander can poll, evaluate and manage the POS system
data. You are thus informed at any time about sales-, or-
der- or working time data etc.
Vectron Commander serves for display or printout of
reports. For this purpose you can use the supplied report
templates or create and adjust reports according to your
requirements.
You can poll data from or send data to several POS sys-
tems simultaneously. Furthermore you can configure
operators with individual authorizations.
The Vectron POS Anywhere function enables you to con-
nect via network or modem to POS systems and control
them remotely and to monitor operating procedures.
Vectron Commander can be used as interface between ex-
ternal software (for instance merchandise control systems)
and Vectron POS systems.