Operation Manual
Vectron POS Mini16
Vectron POS Mini 17
7 Operation
This chapter gives an overview on the functions of your Vectron
POS Mini and an introduction into the basic operating procedures.
Your Vectron dealer has programmed your POS system to meet your
operating requirements. Because of this some operating procedures
may differ from those described in this manual. Your Vectron dealer
will fully explain the functions installed for you.
7.1 Log on and off at the cash register
The clerk must log on to the Vectron POS Mini in order to enter PLUs
or hold-buffers. Thus you can verify at any time which clerk has
made which entries. Different users can be vested with different
authorizations, e.g. void.
There are various possibilities to log on to or off the Vectron POS
Mini.
7.1.1 Log on with key
You log on to the Vectron POS Mini by holding the key to the lock (see
above). If an additional secret number has been programmed, enter
this number and conrm with <Enter>.
7.1.2 Log on without key
Log on without key is possible in case you have been assigned a
clerk number. Enter this clerk number and conrm with <Enter>. If
required, enter your secret number and conrm with <Enter>.