Operation Manual

VECTRON POS MINI II

4.3. Use as directed

Mini II may be used as POS system. The power supply

Vectron PS30 may be used for supplying the Mini II with

power.

Use the supplied power cord with safety plug to connect

Mini II and power supply Vectron PS30 to a grounded

socket. Using other power supplies and power cords is not

as directed. The power supply network must be protected

with a fault current circuit breaker.

Mini II and power supply Vectron PS30 must not be

opened. During normal operation of Vario II the port cov-

ers must not be removed from the ports. POS system and

accessories must not be changed.

The operating company of Mini II is responsible for storage

and backup of data created with the Mini II. The data is to

be processed and stored in such a way that they comply

with e.g. the demands of fiscal authorities.

Depending on configuration and programming of the Vec-

tron POS software, operators can modify the stored data,

configuration and programming of the Mini II, for instance

the PLU- or rights table for operators. Furthermore, opera-

tors can carry out functions like void if these are enabled

in the rights management of the POS system.

You should protect yourself against undesired changes of

the above mentioned parts of programming. This can be

achieved by using operator keys, RFID cards and pass-

words.

Each operator should be assigned his required authoriza-

tion in the rights table of the POS system. Operator keys

and RFID cards, which enable these rights, must exclusively