Operation Manual

81
Supplement
Important notes for the connection of scales
When connecting scales you have to heed the respective natio-•
nal regulations. Within the EU it applies: You require a test cer-
tificate for the respective combination of Vectron POS System,
software and scales. The conditions mentioned therein must be
fulfilled.
Check of certified software•
Proceed as follows to check that the Vectron POS system
runs the correct software:
Switch off the POS system.•
Touch the screen and keep it touched.•
Switch on the POS system.•
Touch the screen until „Starting drivers ...“ and then •
„Calibration is cleared in n seconds“ is displayed.
Touch the „Module inform.“ button.•
„Scale generic protocol 02/04 Version 1.01a“ must be
displayed (see below).