Owner`s manual

VECTRIX ZEV OWNER’S MANUAL 43
SYMPTOM POTENTIAL CAUSE POTENTIAL SOLUTION
Scooter does not turn on Key not properly engaged Recheck key in ignition, turn off/on again
Scooter on but no ‘ready’ light Power on/off switch not engaged Recheck switch, turn off/on
Scooter plugged in to AC Unplug scooter and store plug fr riding
Throttle not set Call Vectrix authorized dealer for instructions
Ready light flashing Side stand switch not engaged Check stands/deploy and retract/check connection
Charger not working A/C power missing Check A/C outlet for power, A/C source check fuse/voltage
Premature charge termination Charger and battery unsynchronized Run bike until battery icon blinks and fuel gauge resets to ‘0’ and charge bike.
Charger firmware out of date Call dealer for service. Technician must determine charger firmware revision and
update minimum Rev 2012, or thereafter.
Handlebars wobble (shimmy) Tire pressure Inflate to correct tire pressure (see tire section)
Deformed front tire Replace / balance front tire with the same tire supplied from the factory
Bald tire (excess wear) Replace / balance tire with the same tire supplied from the factory
Cargo box installed Check the bike behavior without cargo box. Never exceed the maximum load
allowed in the cargo box.
Flashing wrench / battery No charger output Contact your authorized dealer
Flashing wrench / battery /
temperature
Battery air-plenum Contact your authorized dealer
Flashing temperature / battery Battery temperature greater than 50°C
Or
Battery temperature sensor data error
Contact your authorized dealer
Flashing battery Shorted cell
Or
15°C temperature difference at once sensor
compared to the average temperature of the
battery pack
TROUBLESHOOTING