Owner`s manual

VECTRIX ZEV OWNER’S MANUAL 17
SIDE STAND
The side stand is located on the left side of the
Vectrix. To lower the stand, push down on the side
stand bar, which protrudes out from the side stand.
Park on level hard surfaces. Avoid parking on hills or
unstable ground.
To put the stand back up, move the Vectrix to a
vertical position and lift the side stand bar with your
foot.
CENTER STAND (OPTIONAL)
The center stand is an optional feature of the Vectrix.
To lower the center stand, push down on the thrust
arm with your foot while slowly pushing the bike in
the rearward direction. The Vectrix should “snap”
onto the stand. To disengage the center stand, rock
the Vectrix forward and make sure the center stand
is properly retracted.
Never park your Vectrix on soft earth. You should make
every attempt to park your Vectrix on a level, hard
surface.
Always park in an area where you are visible to other
motorists, so as to avoid possible damage to your
Vectrix.
Thrust Arm
SIDE AND CENTER STANDS
WARNING!
Do not sit on the Vectrix while the stand is down.
NOTE!
Always check the ground before putting the side
or center stand down to ensure that the ground is
stable. Hot temperatures can cause the stand to
sink into the pavement, so it is recommended to
have a small metal plate for the stand to rest on
in high heat.
WARNING!
The side and center stands must be in the upright
position in order to safely operate the Vectrix. Failure
to move the stand up could result in injury to both you
and the Vectrix. There is an interlock which prevents
the Vectrix from being enabled unless the side stand
is in the up position.
NOTE!
There is a telltale on the middle of the instrument
panel that will illuminate when the side stand is
down.