User`s guide

Vectrix Electric MAXI-Scooter User’s Guide 41
WARNING!
Driving on tires with little or no tread is
dangerous and could cause an accident.
Checking your tread depth is extremely
important. Failure to do so could result in
riding on bald tires, which can cause injury
or death especially in wet conditions.
TIRES
PROPER TREAD DEPTH
It is recommended to replace the tire when the
tread is below 2mm.
TO REPLACE THE REAR TIRE....
• Make sure that the scooter is turned “off”.
• Raise the scooter up on its center stand on a
fi rm, level surface such that the rear tire is off
of the surface.
• Remove the rear brake caliper from the brake
side swingarm.
• Remove nut, fl at washer, and lock washer from
the brake side of the rear axle.
• Remove the four (4) nuts and washers which
fasten the brake side swingarm to motorside
swingarm near the pivot point.
• Move the brakeside swingarm out of the way.
• Remove the six (6) fasteners which secure the
rear rim to the gearbox.
• Slide the rear rim/ fl at tire assembly over the
rear axle and out of the way.
• Repair/ Replace the tire on the rim and infl ate
to the proper tire pressure.
• Slide the repaired/replaced tire/wheel assem-
bly over the rear axle and secure to the gear-
box with the six (6) fasteners.
• Place the brakeside swingarm back in position
and secure it to the motorside swingarm using
the four (4) nuts and washers.
• Attach the motorside swingarm to the rear
axle using fi rst the fl at washer, then the lock
washer and then the nut.
• Reinstall the rear brake caliper by sliding it
over the brake rotor and then fastening it to
the motorside swingarm.
• Check that the rear wheel is secure and that
the rear brake is functioning by exercising the
rear brake lever.
• Retract the center stand to complete the
operation.