Specifications

Embedded System Tools Guide (EDK 6.2i) www.xilinx.com 57
UG111 (v1.4) January 30, 2004 1-800-255-7778
PBD Editor
R
Viewing Object Information
To view information about an object in the workspace, place the cursor over the object. A
box appears supplying information about the object (name, IP name, bus pin type, etc.).
Zooming in the Workspace
You can use menu commands to zoom the display in the workspace.
Drawing Non-Electrical Objects
Non-Electrical Objects are graphic only and have no electrical meaning in the block
diagram. You can draw these non-electrical objects in the PBD Editor:
x Arcs
x Circles
x Lines
x Rectangles
x Text
To draw a non-electrical object:
1. In the
Add menu, select the object (Arc, Circle, Line, Rectangle, or Text) you want to
draw, or select the toolbar icon for the object.
Zooming Behavior Menu Command Toolbar Icon
Zoom in
Select
View o Zoom o In, or click the Zoom In
toolbar button.
Zoom out
Select
View o Zoom o Out, or click the Zoom
Out toolbar button.
Zoom to display
the entire
schematic or
symbol in the
workspace
Select
View o Zoom o Full View, or click the
Zoom Full View toolbar button.
Zoom to an area
you select
Select
View o Zoom o To Box, or click the
Zoom To Box toolbar button.
Zoom in or out as follows:
x To zoom in, draw a bounding box around the
area from the top left corner of the area to the
bottom right corner.
x To zoom out, draw a bounding box from the
bottom right corner to the top left corner.
Zoom to display
selected objects at
the highest
magnification
1. Select the objects you want to center in the
workspace.
2. Select
View o Zoom o To Selected, or click
the Zoom To Selected toolbar button
.