Specifications

214 www.xilinx.com Embedded System Tools Guide (EDK 6.2i)
1-800-255-7778 UG111 (v1.4) January 30, 2004
Chapter 13: Xilinx Microprocessor Debugger (XMD)
R
x xstats target [options]
Display the simulation statistics for the current session.’reset’ option can be
provided to reset the simulation statistics.
x xtargets [target]
Print the target ID and target type of all current targets or a specific target.
x xtraceopen target [filename]
Open a trace file to collect trace information. If filename is not specified, isstrace.out is
used as the default filename.Note: This command is only for PowerPC ISS target.
x xtracestart target
Start collecting trace information. Trace file should be opened before trace start.Note:
This command is only for PowerPC ISS target.
x xtracestop target
Stop collecting trace information.
Note: This command is only for PowerPC ISS target.
x xtraceclose target
Close the trace file.
Note: This command is only for PowerPC ISS target.
x xprofile target [-o <GMON Output File>]
Generate Profile output that can be read by mb-gprof or powerpc-eabi-gprof.
x xforce_use_fsl_dow target
Force XMD to use FSL based fast download. This command should be used when the
cable type is xilinx_svffile, when reading from target is not possible. Especially when
SystemACE file is generated.
x xuart <r|w|s> [ <data> ]
Perform one of 3 UART operations on the MDM’s UART if it is enabled. This
command is valid only for the MDM target.
xuart <r> - Read byte from the MDM UART
xuart <w> <data> - Write byte onto the MDM UART
xuart <s> - Read the status of MDM UART