Specifications

Embedded System Tools Guide (EDK 6.2i) www.xilinx.com 191
UG111 (v1.4) January 30, 2004 1-800-255-7778
PowerPC Target
R
Example debug session with a PowerPC target
This example demonstrates a simple debug session with a PowerPC target. Basic xmd-
based commands are used after connecting to the PowerPC target using the “ppcconnect”
command. At the end of the session, GDB (powerpc-eabi-gdb) is connected to xmd using
the GDB remote target. Refer to the GDB section of the est_guide for more information
about about connecting GDB to xmd.
XMD% ppcconnect
JTAG chain configuration
--------------------------------------------------
Device ID Code IR Length Part Name
1 05026093 8 XC18V04
2 0123e093 10 XC2VP4
assumption: selected device 2 for debugging.
Figure 13-2: PowerPC Target
X9988
JTAG
XMD
P
PC 405 JTAG Signals
JTAGPPC
PowerPC 405