Specifications

186 www.xilinx.com Embedded System Tools Guide (EDK 6.2i)
1-800-255-7778 UG111 (v1.4) January 30, 2004
Chapter 13: Xilinx Microprocessor Debugger (XMD)
R
XMD Usage
To start the XMD engine, execute xmd from a shell as follows.
> xmd [xmd Tcl script]
On startup, XMD does the following:
x If an xmd TCL script is specified, xmd will execute the script and quit.
x Otherwise, xmd will be started in an interactive mode. In this case, if there is a file
named xmd.ini in the current directory, xmd will source the xmd.ini as if it is a Tcl
script file, before presenting the XMD% prompt From the xmd Tcl prompt, xmd can be
connected to the desired target using the commands described in the following
sections. After connecting to a target, commands described in Table 13-1 can be used.
Figure 13-1: XMD Targets
X10135
Tcl/Terminal Interface
MicroBlaze Instruction
Set Simulator
MicroBlaze
Hardware Board
PowerPC
Hardware Board
PowerPC
ISS
GDB Remote Protocol
GDB
mb-gdb
or
PowerPC-eabi-gdb
(TCP/IP)
XMD