Specifications

CHAPTER 12: DEBUGGING

USING SIGNALPROBE

ALTERA CORPORATION INTRODUCTION TO QUARTUS II ■ 205

Figure 6. Mnemonic Table Setup Dialog Box

Using SignalProbe

The SignalProbe feature allows you to route user-specified signals to output

pins without affecting the existing fitting in a design, so that you can debug

signals without needing to perform another full compilation. Starting with a

fully routed design, you can select and route signals for debugging through

I/O pins that were either previously reserved or are currently unused.

For Information About Refer To

Using the SignalTap II Logic Analyzer “Design Debugging Using SignalTap II

Embedded Logic Analyzer,” in the

Quartus II Handbook, vol. 3, on the Altera

web site

“Overview: Using the SignalTap II Logic

Analyzer” in Quartus II Help