Specifications

CHAPTER 11: PROGRAMMING & CONFIGURATION

USING THE QUARTUS II SOFTWARE TO PROGRAM VIA A REMOTE JTAG SERVER

194 ■ INTRODUCTION TO QUARTUS II ALTERA CORPORATION

Using the Quartus II Software to

Program Via a Remote JTAG Server

In the Hardware Setup dialog box, which is available from the Hardware

button in the Programmer window or from the Edit menu, you can add

remote JTAG servers, which you can connect to, for example, to use

programming hardware that is not available on your computer, and

configure local JTAG server settings so remote users can connect to your

local JTAG server.

You can specify that remote clients should be enabled to connect to the JTAG

server in the Configure Local JTAG Server dialog box, which is available

from the JTAG Settings tab of the Hardware Setup dialog box.

You can specify the remote server you want to connect to in the Add Server

dialog box, which is available from the JTAG Settings tab of the Hardware

Setup dialog box. When you connect to a remote server, the programming

hardware that is attached to the remote server will be displayed in the

Hardware Settings tab.

For Information About Refer To

Using a Local JTAG Server “Configuring Local JTAG Server Settings,”

and “Adding a JTAG Server” in Quartus II

Help