Specifications

CHAPTER 11: PROGRAMMING & CONFIGURATION
CREATING SECONDARY PROGRAMMING FILES
ALTERA CORPORATION INTRODUCTION TO QUARTUS II ■ 193
7. (Optional) Add, remove, or change the order of SOFs and POFs to be
converted for one or more SOF Data item(s) or POF Data item.
8. (Optional) Add a HEX File to a Bottom Boot Data or Main Block Data
item for a POF for an EPC4, EPC8, or EPC16 configuration device, and
specify additional properties of SOF Data items, POF Data items, and
HEX Files.
9. Save the current state of the Input files to convert list and the output
programming file settings in a Conversion Setup File.
10. Convert the file. If you want, you can also specify a Memory Map File
to be created.
)
f
For Information About Refer To
In-system programmability and
in-circuit reconfigurability
Configuration Handbook on the Altera web
site
Application Note 100 (In-System
Programmability Guidelines) on the Altera
web site.
Application Note 95 (In-System
Programmability in MAX Devices) on the
Altera web site.
Application Note 122 (Using Jam STAPL for
ISP & ICR via an Embedded Processor) on
the Altera web site.
Application Note 298 (Reconfiguring
Excalibur Devices under Processor Control)
on the Altera web site
In-system programming The Programming module of the Quartus II
Tutorial
Remote system configuration “Using Remote System Configuration with
Stratix & Stratix GX Devices” and “Using
Remote System Configuration with
Stratix & Stratix GX Devices” in the Stratix II
Device Handbook, vol. 2, on the Altera web
site