Installation manual

Série 32 Mlift Vector - Prog.Vectorielle Installation manual Chapter V - page 15
DOUBLE SELECTIVE SERVICE LANDING CALLS (1/3)
Principe:
The notion of double selective service is to made a selective opening of the front or
rear door.
This require 2 car buttons box (one for each side !).
In the same way, for the landing calls, it must be possible to connect together the
front and rear door for a same floor
When the 32 serie is meant to drive 2 selective service, it is necessary to 'split' the
car and landings calls.
The 32 serie can delivered 16 levels maxi. (BG15 + 3 BG18 floor boards) on Single
or Double non selective service, this capacity is reduce at 8 Levels in case of double
selective service.
Note:
• To create a controller with 2 to 4 Levels on Double Selective Service,
You needs the main board BG15 + 1 BG18 levels boards;
• To create a controller with 5 to 8 Levels on Double Selective Service,
You needs the main board BG15 + 3 BG18 levels boards.
EXAMPLE: CONNECTION FOR A CONFIGURATION OF 4 LEVEL
CONCERNING THE CAR CALLS:
The inputs C0 to C3 (BG15, KC21) correspond at the calls for the level 0 to 3 of the front door.
The inputs C4 to C7 (BG18 (1), KCx) correspond at the calls for the level 0 to 3 of the rear door.
CONCERNING THE LANDING CALLS FOR DOWN:
The inputs M0, D1 to D3 (BG15, KP21) correspond at the calls for the level 0 to 3 of the front door.
The inputs D4 to D7 (BG18 (1), KPDx) correspond at the calls for the level 0 to 3 of the rear door.
CONCERNING THE LANDING CALLS FOR UP:
The inputs M1 to M3 (BG15, KP27) correspond at the calls for the level 1 to 3 of the front door.
The inputs M5 to M7 (BG18 (1), KPMx) correspond at the calls for the level 1 to 3 of the rear door.
If there is no door at some level, of course, there is nothing connecting on the
corresponding input!!!
CAR DOWN LANDING UP LANDING
LEVEL BG15 BG18
(1)
BG18
(2)
BG18
(3)
BG15 BG18
(1)
BG18
(2)
BG18
(3)
BG15 BG18
(1)
BG18
(2)
BG18
(3)
7
C7 D7 X
F6
C6 D6 M6
A5
C5 D5 M5
C4
C4 D4 M4
E3C3
D3 M3
2 C2
D2 M2
11C1
D1 M1
0 C0
M0 X
7
C7 D7 X
F6
C6 D6 M6
A5
C5 D5 M5
C4
C4 D4 M4
E3
C7 D7 M7
2
C6 D6 M6
21
C5 D5 M5
0
C4 D4 X