Installation manual

Série 32 Mlift Vector - Prog.Vectorielle Installation manual Chapter V - page 4
COMBINATION OF ELECTRONICS BOARDS
In function of: number of level, number of button at the each landing and the controller
type.
The table below indicates the different combination between the electronics boards
BG15 (Main board), BG18 (Levels boards) and BG19 (2nd service board) includes in your
controller, in function of the number of levels (2 to 16 Levels), buttons at each landing (1 or
2 buttons) and your controller type (collective 1 button, Full collective, double selective
service).
The table below indicates which interception direction at a given landing, in function
of the different parameter state.
When the segment Base 8N is switching on, the equipment MB32 works on SAPB mode
or Collective 1 button per landing.
When the segment BLOCAG is switching on, the equipment MB32 works on SAPB mode,
if the segment is switching off, the equipment works on Down collective mode.
For reasons describes above at the parameter-segment Base 8N, the software forced the
switching off of the segment Ramdes if you have switching on, one of the segment below:
• DServS - address 02, segment 2. (Double Selective SERVice?)
• NivSin - address 02, segment 3, (Level damaged?)
• DPLX - address 02, segment 6. (DuPLeX?)
BG15 BG18
(1)
BG18
(2)
BG18
(3)
BG19 Drawing
page
Single automatic operation 2 to 8 level X---- 5
Single automatic operation 9 to 12 level X X X - - 7
Single automatic operation 13 to 16 levelXXXX - 7
Collective operation 1 button 2 to 8 levelX---- 9
Collective operation 1 button 2 to 16 levelXXXX - 11
Full collective operation 2 to 4 level X---- 13
Full collective operation 5 to 8 level X X - - - 13
Full collective operation 9 to 12 level X X X - 13
Full collective operation 13 to 16 level XXXX - 13
Double selective service 2 to 4 level X X - - X 15
Double selective service 5 to 8 level XXXXX 15
In any case, the segment Base 8N light on !
Segment Segment Segment Segment Interception direction
BLOCAG
Ramdes
MsqDE MsqMo
on landing
Lit indifferent indifferent indifferent Single automatic
Unlit Unlit indifferent indifferent in Down for all levels
Unlit Lit Unlit Unlit No interception
Unlit Lit Lit Unlit in Down
Unlit Lit Unlit Lit in Up
Unlit Lit Lit Lit In both direction (*)
(*) When the both segments Base 8N and Ramdes are lit, the sofware of the
controller MB32 forced the switching on of the Parameter-segment EFFNSEL (Call
cancel o
p
tion / EFFacement Non Sélectif ?
)
-address 08, se
g
ment 3.