Installation manual

Série 32 Mlift Vector - Prog.Vectorielle Installation manual Chapter I - page 35
T
O CHANGE THE PARAMETERS
Check that the RAM-PAR switch is to PAR.
RAM
PAR
A) In digit mode

Go to the parameter address as explained on the page before (e.g. 03).
RAM
PAR
ADR/DON
MODIF
ECRIT
BG17
1 second later ...
RAM
PAR
ADR/DON
MODIF
ECRIT
BG17

Slide the ADR/DON-MODIF switch to MODIF.
ADR/DON
MODIF
2

Use the push buttons to increase/decrease to the new value (e.g. 02).
RAM
PAR
ADR/DON
MODIF
ECRIT
BG17
3
Push once on the right-hand
button
to change the value from 01 to
02.
RAM
PAR
ADR/DON
MODIF
ECRIT
BG17

Register the new value by pushing and releasing both buttons
at the same time.
RAM
PAR
ADR/DON
MODIF
ECRIT
BG17
4

Slide the ADR/DON-MODIF switch back to ADR/DON. Address 03 will
show followed by its value 02.
ADR/DON
MODIF
5