Installation manual

Série 32 Mlift Vector - Prog.Vectorielle Installation manual Chapter I - page 34
To change the address or to view the inputs, outputs and parameters
To remind yourself of the current address

Check that the ADR/DON-MODIF switch is on ADR/DON.
ADR/DON
MODIF
1

Scroll to the desired address (eg 03) by pressing the push buttons below the display.
Press either button and the address will be displayed. Each time you press a button the value
displayed will be increased by 1.
RAM
PAR
ADR/DON
MODIF
ECRIT
BG17
Press the right hand button 10
times to change
from address 09 to address 03
RAM
PAR
ADR/DON
MODIF
ECRIT
BG17
Leave the buttons for 1 second, and the contents of the selected address will be displayed
indefinitely.
RAM
PAR
ADR/DON
MODIF
ECRIT
BG17
1 second later ...
RAM
PAR
ADR/DON
MODIF
ECRIT
BG17
If you forget the address you are at,

Slide the ADR/DON-MODIF switch to MODIF.
ADR/DON
MODIF
1

Then slide it back to ADR/DON. This will show you the address for 1
second, and then the contents.
ADR/DON
MODIF
2