Installation manual

Série 32 Mlift Vector - Prog.Vectorielle Installation manual Chapter I - page 33

ISPLAY MODES

Depending on the information to be displayed, the MB32 VECTOR uses the most

appropriate method of showing the information.

Digit Mode

The

digit mode

is useful to read or programme times, or the number of floors, or the number

of doors for example.

Example: If we have 2 door operators, we program 02 at address 03.

Segment Mode

The segment mode uses the individual vertical segments on the display as shown below.

This mode is useful to activate or deactivate different functions:

Example: To activate the "flashing direction arrows" option, segment 5 at

address 08 must be ON.

The segment mode is also useful to view the state of inputs and outputs:

Example: To check that the

input (car call to level 0) is correctly read by

the MB32 VECTOR, you need to look at segment 0 at address

00.

To change from digit to segment mode and vice-versa, slide the ADR-DON-MODIF switch

to ADR/DON and press both buttons at the same time, and release.

Segment 6 Segment 5

Segment 7 Segment 4

Segment 3 Segment 0

ment 2 Se

ment 1