Installation manual

Série 32 Mlift Vector - Prog.Vectorielle Installation manual Chapter I - page 30
T
O CHANGE THE PARAMETERS IN SEGMENT MODE
You can access the options using segments and change them if so desired.
Seg0 : IG, Seg1 : NOBAND, Seg2 : BATTERY, Seg3 : MLI,
Seg4 : RETSEC, Seg5 : APPDIR, Seg6 : D65°, Seg7 : ML220V
Reset the display by pressing
both CLEAR buttons
at the same time
Display address 00E
by pressing button 1
Press both MODIF buttons
at the same time
000 V0 0,150m/s
MODIF. CLEAR VALID.
1000 100 10 1
00E Opt 00000000
11 x
MODIF. CLEAR VALID.
1000 100 10 1
MDF Bt1 0
MODIF. CLEAR VALID.
1000 100 10 1
Press button 10
to obtain the required segment
example: Direct approach.
Press button 1
to activate segment 5.
Register the new data in the
memory by pressing both VALID
buttons at the same time.
MDF Bt5 0AP-DIR
5 x
MODIF. CLEAR VALID.
1000 100 10 1
1 x
MDF Bt5 1AP-DIR
MODIF. CLEAR VALID.
1000 100 10 1
MDF Bt5 1AP-DIR
MODIF. CLEAR VALID.
1000 100 10 1