Installation manual

Série 32 Mlift Vector - Prog.Vectorielle Installation manual Chapter I - page 28
Other example:
V
IEWING THE INCREMENTAL ENCODER IMPULSES
(S
EE PAGE
21).
T
RANSFER OF THE SETTINGS INCLUDED IN THE
VVVF
TOWARD THE DIAGNOSTIC TOOL
.
Reset the display to address 000
by pressing the CLEAR buttons
simultaneously
Display address 116 using
buttons 100, 10 and 1
000 V0 0,150m/s
MODIF. CLEAR VALID.
1000 100 10 1
116 Codeur 0635
6 x1 x1 x
MODIF. CLEAR VALID.
1000 100 10 1
The value displayed at address
116
increases when the rotor turns
in the upwards direction
The value displayed at address
116
decreases when the rotor turns
in the downwards direction
116 Codeur 0975
MODIF. CLEAR VALID.
1000 100 10 1
116 Codeur 0328
MODIF. CLEAR VALID.
1000 100 10 1
Press the 2 end buttons to make
«
READ PARAMETERS
»
appear.
Validate by pressing the
« VALID » buttons
..... Transfert
Press the 2 end buttons
to return to normal mode
READ PARAMETERS
MODIF. CLEAR VALID.
1000 100 10 1
READ Adr.
MODIF. CLEAR VALID.
1000 100 10 1
F8xx
MODIF. CLEAR VALID.
1000 100 10 1
000 V0 0,150m/s
Note: You can memorise in the E²ROM of the box, the parameters of 4 VVVF door drive, respectively at the
addresses 00, 40, 80 or C0. For that, press the 2 end buttons than press « MODIF » button and modify the
right number to 00, 40, 80 or C0 with the 10 button than press « VALID » to validate.
READ PARAMETERS
MODIF. CLEAR VALID.
1000 100 10 1
40 Octets < - 00
MODIF. CLEAR VALID.
1000 100 10 1
MODIF. CLEAR VALID.
1000 100 10 1
x 8
40 Octets < - 00
40
80
C0
Ex: Copy the VVVF parameters at
address 80 in the box
MODIF. CLEAR VALID.
1000 100 10 1
READ Add. F8xx