Installation manual

Série 32 Mlift Vector - Prog.Vectorielle Installation manual Chapter VII - page 101
PARAMETERS CONCERNED THE SLOTTED TAPE
ZONEPV = SLOW SPEED ZONE
ZONARD = DOWN STOPPING ZONE
STOPPING POINT
ZONARM = UP STOPPING ZONE
ZONEPV = SLOW SPEED ZONE
ZDEVER = DOWN DOOR UNLOCKING ZONE
ZDEVER = UP DOOR UNLOCKING ZONE
LEVEL L
All of the information shown in the above table is shown in millimetres and in
decimal, except the floor heights.
When the information is given over 2 addresses, the first address shows the
thousands and hundreds, and the second shows the tens and units.
Name Designation Address
ZDEVER DOOR UNLOCKING ZONE ............................................... d4 and d5
ZONARM UP STOPPING ZONE ....................................................... d2
ZONARD DOWN STOPPING ZONE ................................................. d3
ZONYST HYSTERISIS ZONE ........................................................... b6
Parameters linked to the relevelling
TPISO RELEVELLING TIMING 19
BNDISO RELEVELLING JUMP ....................................................... bC
ZONARI RELEVELLING STOPPING ZONE .................................... d7
Parameters linked to the slow-down distance
DMINV2 MINIMUM DISTANCE FOR V2........................................... d8 and d9
ZONPV1 SLOW SPEED ZONE 1 = V1 SLOW DOWN DISTANCE .. dA and db
ZONPV2 SLOW SPEED ZONE 2 = V2 SLOW DOWN DISTANCE .. d0 and d1
Parameters linked to the floor heights
ALTNIV00
to
ALTNIV11
…
ALTNIV15
Floor Height Level 00 .......................................................
to
Floor Height Level 11 (Alpha Serie) .....................................
…
Floor Height Level 15 (32 Serie)..........................................
For the floor heights
automatic set-up of levels
81 and 80
to
8F and 8E
…
9F and 9E
Example:
For a slow-down distance (or slow speed zone) of 800 mm (80 cm), you will read 08 at
address d0, and 00 at address d1, i.e. 0800 millimetres.