Installation manual

Série 32 Mlift Vector - Prog.Vectorielle Installation manual Chapter VII - page 90
OUTPUTS DEFINITIONS
Segment
3
:
VSU
(Overload Light) (S ELEC).
This shows us the state of the Overload Light Output (VSU).
Segment 3 is on when the VSU Output is activated and gives out 0 Volts.
Segment 3 is off when the VSU Output is de-activated and gives out 24 Volts.
Segment
2
:
RF
(Buzzer) (S ELEC).
This shows us the state of the Overload Buzzer (RF).
Segment 2 is on when the RF Output is activated and gives out 0 Volts.
Segment 2 is off when the RF Output is de-activated and gives out 24 Volts.
Segment
1
:
VHS
(Out of Service Light) (S ELEC).
This shows us the state of the Out of Service Light Output. (VHS).
Segment 1 is on when the VHS Output is activated and gives out 0 Volts.
Segment 1 is off when the VHS Output is de-activated and gives out 24 Volts.
Segment
0
:
VPMP
(Fireman Service Light) (S ELEC).
This shows us the state of the Fireman Light Output (VPMP).
Segment 0 is on when the VPMP Output is activated and gives out 0 Volts.
Segment 0 is off when the VPMP Output is de-activated and gives out 24 Volts.
• Ram Address
16
: best displayed in segment mode.
Segment
0
to
7
:
QC0-7
(Car Registration Lights 0 - 7) (S ELEC).
These show us respectively the state of the Car Registration Lights QC0 to QC7.
Outputs QC0 to QC7 are the terminals C0 to C7.
The corresponding segments are on when the Outputs are activated and give out 0 Volts.
The corresponding segments are off when the Outputs are de-activated and give out 24
Volts.
• Ram Address
17
: best displayed in segment mode.
Segment
0
to
7
:
QC8-15
(Car Registration Lights 8 - 15) (S
ELEC).
They show us respectively the state of the Car Registration Lights QC8 to QC15.
Outputs QC8 to QC15 are the terminals C8 to C15.