Installation manual

Série 32 Mlift Vector - Prog.Vectorielle Installation manual Chapter VII - page 84
INPUTS DEFINITIONS
• Ram Address
11
:
best displayed in segment mode.
Segment
7
: Not used.
Segment
6
: Not used.
Segment
5
: Not used.
Segment
4
: Not used.
Segment
3
:
EXD
(Extreme Down Contact).
This shows us the state of the Extreme Down Contact.
Segment 3 is on when the contact is open, i.e., when the car is below the bottom ED
magnet ED.
Segment 3 is off when the contact is closed, i.e., when the car is above the bottom ED
magnet ED.
Segment
2
:
EXM
(Extreme Up Contact).
This shows us the state of the Extreme Up Contact.
Segment 2 is on when the contact is open, i.e., when the car is above the top EM magnet.
Segment 2 is off when the contact is closed, i.e., when the car is below the top EM
magnet.
Segment
1
:
CAB
(Tape head, Harness B).
This shows us the state of Harness B.
Segment 1 is on when harness B is open.
Segment 1 is off when harness B is closed.
Segment
0
:
CAA
(Tape head, Harness A).
This shows us the state of Harness A.
Segment 0 is on when harness A is open.
Segment 0 is off when harness A is closed.