Installation manual

Série 32 Mlift Vector - Prog.Vectorielle Installation manual Chapter VII - page 63
PARAMETER DEFINITIONS
Segment
0
:
OUNSIMN0
(Non-Simultaneous Door Opening at
Level 0).
We program segment 0 to " 1 " when we wish to prevent the simultaneous opening of
doors 1 and 2 at level 0 (Locking effect).
We program segment 0 to " 0 " when we authorise the simultaneous opening of doors 1
and 2 at level 0.
This function can only be used with the double service selective.
• Par Address
49
: best displayed in segment mode.
At this address, we define the operation of door 1 for level 1.
• Par Address
4a
: .. Same for level 02. • Par Address
51
: .. Same for level 09.
• Par Address
4b
: .. Same for level 03.
• Par Address
52
: .. Same for level 10.
• Par Address
4d
: .. Same for level 05. • Par Address
54
: .. Same for level 12.
• Par Address
4e
: .. Same for level 06 • Par Address
55
: .. Same for level 13.
• Par Address
4f
: .. Same for level 07. • Par Address
56
: .. Same for level 14.
• Par Address
50
: .. Same for level 08. • Par Address
57
: .. Same for level 15.
• Par Address
58
:
TDEMYD
(Start-up time Star Delta) best displayed in hexadecimal.
At this address, we program the time during which we want the STAR contactor to be on.
We can program a time from 0 to 25.5 seconds at intervals of 0.1 seconds.
See page 94 for the conversion between decimal and hex, from 0 to 255 ....... 00 to FF.
• Par Address
59
:
TARMVT
(Movement Stop Time) best displayed in hexadecimal.
At this address, we program the time during which the ascent Slow Speed distance valve
continues to be fed after the stopping point.
We can program a time from 0 to 2.55 seconds at intervals of 0.01 seconds.
See page 94 for the conversion between decimal and hex, from 0 to 255 ....... 00 to FF.
• Par Address
5A
:
TPMPVM
(Movement Extension time for the Ascent Slow Speed
Distance) best displayed in hexadecimal.
At this address, we program the extra time we need to feed the motor.
We can program a time from 0 to 2.55 seconds at intervals of 0.01 seconds.
See page 94 for the conversion between decimal and hex, from 0 to 255 ....... 00 to FF.