Installation manual

Série 32 Mlift Vector - Prog.Vectorielle Installation manual Chapter VII - page 57
PARAMETER DEFINITIONS
• Par Address
38 to 3F
: best displayed in segment mode.
We will see later, at address 5B (programmed has 04), that we can program the Series 32
driven hydraulic type.
It could be that a new kind of hydraulic unit which functions differently appears and does
not correspond 100% with the pre-programmed types.
From addresses 38 to 3F, it is possible to define a particular function for a particular
hydraulic unit.
Each address to be defined corresponds to the STATE of the valves and contactor for
each stage of a movement.
This sequence is the same whatever type of hydraulic, but the way in which to carry out
each stage differs depending on the unit (number of different types of valves, different
procedures etc...).
Each address, from 38 to 3F represents a stage and we assign the contactors and the
valves to an address which must be activated by it.
We program the segment to " 1 " when we wish to activate a part in this stage.
EXAMPLE OF SPECIAL DEFINITION FOR HYDRAULIC SEQUENCE
Address V4 V3 V2 V1 L ∆ YStage
38 1 1 1 1 1 Up high speed L, Y
39 1 1 1 1 1 Up high speed L, ∆
3A 1 1 1 1 Up slow speed L, Y
3B 1 1 1 1 Up slow speed L, ∆
3C 1 1 1 Complete stop, up
3D 1 1 1 1 1 1 Down, high speed, L
3E 1 1 1 1 1 Down, low speed, L
3F 1 1 1 1 Complete stop, down L
Segment Seg 7 Seg 6 Seg 5 Seg 4
Seg 3
Seg 2 Seg 1 Seg 0
Valve
Valve for
high speed
Valve for
slow speed
Up
direction
Down
direction