System information

Installing Hardware Options
MicroVAX 3100 Models 88/98 User Information
3-11
enclosure; seat removable media devices (such as a CD-ROM) so that the front will be
even with the front of the bezel after it is reinstalled.
7. Insert the screws, Figure 3-7 Item (four total) , through the side of the bay and into
the device as shown. It may be necessary to position the rail slightly to seat it in the
system.
MLO-013611
1
2
3
4
Figure 3-7 Installing Optional Devices in the Front Bay
8. If you are installing a hard drive or other non-removable media device, snap the front
EMI shield back into place over the slot in the enclosure. If you are installing a CD-
ROM or other removable media device, you will leave the EMI shield off the system
so that the front of the device can be accessed. Place the shield in a safe location in
case you wish to remove the device later, or replace it with a hard drive.
9. Connect the SCSI and power cables to the device.
10. Reinstall the front bezel, close the cover, connect the power cord and plug it into the
wall outlet.