System information

Getting Started
2-14
MicroVAX 3100 Models 88/98 User Information
Connecting ThickWire Ethernet
If you are using ThickWire Ethernet, connect it as follows:
1. If you are using ThickWire Ethernet, configure the jumper as in Figure 2-8.
2. Attach the 15-pin connector on the ThickWire Ethernet transceiver cable to the
ThickWire Ethernet port on the rear of the system by sliding the clip upward.
3. Install the ThinWire Ethernet terminator as shown in Figure 2-11.
MLO-013616
Figure 2-11 Installing ThickWire Ethernet